Machine Start And Stop - Clarke Vantage 17 Battery Manuel D'utilisation

EN
ENGLISH

MACHINE START AND STOP

Start
1. Prepare the machine according to the procedure shown
in the previous paragraph.
2. Lower the squeegee (A, Fig. 15) by pushing the lever (B)
downwards.
3. Turn the solution flow control lever (C, Fig. 15) to one of
the following positions, according to the type of cleaning
to be carried out:
– ECO system: When the lever (C, Fig. 15) is in the
"ECO" position (D), the machine works in a special
condition of programmed water "economy" usage; as
the water flow is set and constant, the machine can
work with a cleaning time of 70-80 minutes [0.08
gal/min (0.3 liters/min].
– Variable system: When the lever is turned to the left
(variable flow), it is possible to increase the capacity
up to 0.26 gal/min (1 liter/min) (E, Fig. 15).
During machine operation, it is not possible to completely
close the water flow to the brush/pad.
4. Turn the switches (A and B, Fig. 14) to the "I" position.
NOTE
If the green indicator light (C, Fig. 14) turns on, the
machine is ready to be used.
If the yellow (D) or red indicator light (E) turns on, it
is necessary to charge the batteries (see the
procedure in the Maintenance chapter).
5. While keeping both hands on the handlebar (G, Fig. 15),
start the machine by pressing one or both the activation
switches (F).
Machine Stop
6. Release the switches (F, Fig. 15).
7. Turn the switches (A and B, Fig. 14) to the "0" position.
8. Lift the squeegee by pushing the lever (B, Fig. 15)
completely upwards.
9. Lift the brush/pad by activating (B, Fig. 16) the
transport/parking device (A) after inserting the relevant
pin (C).
14
Figure 14
Figure 15
Figure 16
Operator's Manual - Vantage 17 Battery