Inserting The Drive Battery In The Vehicle; Connecting The Drive Battery To The Speed Controller - Reely Supersonic Notice D'emploi

e) Inserting the Drive Battery in the Vehicle
Attention!
The drive battery must not be connected to the speed controller yet. First switch on the transmitter, see
chapter 9. c) and 9. d).
Important!
This vehicle is exclusively suitable for use with a LiPo drive battery with 3 cells (rated voltage 11.1 V).
When using a drive battery with more cells, there is a danger of fire from overheating of the speed control-
ler. Apart from this, the vehicle's drive will be overloaded and damaged by this (e.g. differential). Loss of
guarantee/warranty!
Remove the hook-and-loop tape (A) of the battery holder.
Now insert the drive battery so that the connection cable
of the rechargeable battery points backwards. Otherwise,
the connection cable could impair the steering mechanism
in its function.
Pull the hook-and-loop tape tight so that the drive battery
is seated firmly, and close the hook-and-loop tape.
f) Connecting the Drive Battery to the Speed Controller
First switch off the speed controller. Put the On/Off switch
(see circle in the figure to the right) into the "OFF" position
for this. Observe the labels next to the slider.
Then switch on the transmitter (see chapter 9. c) and 9.
d)).
Remember to put the trimming for driving into the centre
position.
To prevent sudden start-up of the wheels and therefore uncontrolled starting of the model (e.g. if the trim-
ming for the drive is maladjusted), place the model vehicle on a suitable support (or starting box), so that the
wheels can turn freely in case of an error.
Do not reach into the drive. Do not hold the wheels.
Now connect the drive battery to the speed controller. Ensure correct polarity (red cable = plus/+, black cable =
minus/-). Do not apply any force when connecting the battery plug to the connection of the speed controller.
Make sure that the cables do not get into the drive of the vehicle or the steering mechanics. Use cable binders for
fastening if required.
46
A A
 Æ
OFF ON