Programming - Becker Centronic MemoControl MC42 Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Programming the daily switching times
To set the desired UP switching time, press the UP button for at least 6 seconds.
The transmission control light flashes briefly three times. This control command
will now be repeated every 24 hours.
To set the desired DOWN switching time, press the DOWN button for at least 6
seconds. The transmission control light flashes briefly three times. This control
command will now be repeated every 24 hours.
Note
The travel times can be overwritten at any time. Repeat the program-
ming for the new desired day travel time.
Deleting the daily switching times
In order to delete the UP and DOWN switching time, press the reset button.
Note
When the reset button is pressed (with a pen, for instance), all switch-
ing times, intermediate positions and turning/ventilation positions are
deleted.
Programming the intermediate position
Prerequisite: the roller shutter/venetian blind is at the upper end limit.
1. Press and hold the intermediate position programming button t.
2. Press the DOWN button at the same time until you have reached the re-
quired intermediate position. Adjustments can be made using the UP button
or DOWN buttons.
3. Release the intermediate position programming button t. The intermediate
position has now been saved.
The control light will flash briefly three times.
Deleting the intermediate positions
1. Press the intermediate position programming button t for longer than 5 sec-
onds. The intermediate position has now been deleted.
The control light will flash briefly three times.
Programming the ventilation/reverse position
Prerequisite: the roller shutter / blind is at the lower end limit.
1. Press and hold the ventilation/reverse position programming button s.
2. Press the UP button at the same time until you have reached the required
ventilation/reverse position. Adjustments can be made using the UP button
or DOWN buttons.
18

Programming