Important Notices - Skoda LAS 630 001 Mode D'emploi Et Instructions De Montage

Yeti (5l)

Masquer les pouces

Table des Matières

Les langues disponibles

- 3, 4 -

- Use wrench (C) to unlock the lock of the carrier cap.

- Remove the cap and put it on a suitable place to avoid its

damage.

- Divert the red safety lever and disengage the eccentric lever

upwards.

Attention. Prior to mounting the carrier on longitudinal

rails, all the eccentric levers must be in the upper posi-

tion!

- 5, 6 -

- When the carrier is ready as described above, mount it on to

the screws in the longitudinal carrier of the car (the flanges

of the carrier are movable -detail-).

- Mount the rear crossbeam on the screws as per the re-

quired spacing for fastening additional attachment pieces

(ski holder, bicycle holder, etc.).

- Check whether the carrying metal sheet of the car-

rier flange is positioned correctly on fitting the screws

screwed in the longitudinal carrier -detail-.

- Centre the carrying profiles of the carrier (so-called

quota "a" = "a").

- 7 -

- Check the carrier for proper position.

- With your left hand press the carrying plate of the carrier to

the longitudinal carrier and with your right hand simultane-

ously tilt the eccentric carrier lever to the bottom position

(the lever snaps under the tang of the safety red lever).

- The detent plate of the flange must seat in the screw

groove -detail-.

- 8, 9 -

- Mount the dismantled cap and push until snaps.

- By turning the key, get the lock to horizontal (closed) posi-

tion. Take the key out and save it.

Check the carrier for proper position. Check proper fas-

tening giving it a powerful shake with your hand.

Disassembling

- Proceed in reverse for disassembling the carrier.