Skoda LAS 630 001 Mode D'emploi Et Instructions De Montage page 23

Before each drive check all the pieces for proper position
and fitting.
Check all screwed joints and other connections of the
attachment pieces. In case of need tighten the joints.
Always check the screw connections, other connections
and fastening of the load after short period of your drive.
GB
In case of need re-tighten the joints.
If the condition of the road is not very good, check the
screwed joints in shorter intervals.
If the above instructions are not followed, the carrier or
attachment pieces might get lost - danger of injury.
After 2000 km let an authorized service check the torque
of the screws in the longitudinal carrier.
Always let an authorized service deal with repairs and
replacement of any parts of the crossbar carrier. We re-
commend to use genuine spare parts you receive at your
dealer.
At least once a year grease the cylinder locks using re-
commended agent CONCOR 101.
Maintenance instructions - clean the crossbar carrier
regularly and maintain as advised. Especially in winter
make sure to remove dirt and salt.
After fitting the crossbar carrier (or with attachment
pieces) on the roof of the car the total height of your car
will change. Therefore be extremely careful when driving
into the garage, tunnel or underbridge.
If you transport bulk objects (e.g. ski boxes, bicycles, etc.),
the roof is exposed to more load due to strongly increased
air resistance, therefore adapt the speed of your drive to
the specific conditions.
If you transport load, always follow the safety rules of
respective country.
The manufacturer does not bear responsibility for any
damages caused by improper assembling.