grandimpianti C 200/51 Instructions Pour L'installation Et Mode D'emploi page 63

In the case of steam heating:
 Check the cleanliness of the filter situated on the steam input piping.
 Check the state of the rotating steam input and output casing: the circuit must be
perfectly watertight (no leakage of steam or water). If a leakage appears, it is
imperative to replace the defective casing. Take care, because when in operation
the casing and steam piping are very hot!
Lubrication:
 Lubricate the bearings of the satellites with high temperature lubricant (all machine
models) and cylinder bearings (on steam-heated machines only).
 Also lubricate the drive chains and pinions, not forgetting the drive chain of the
presser roller of the machine.
Settings:
Check the correct tension of the belts, which must be slightly taut and turn without

sliding around the drive satellite.
 In order to re-tighten these belts, loosen the screws at the ends of the intake tablet
and then slide in the tablet.
 Check the tension of the ironing belts. In fact, particularly during the first few times
of operation, the belts tend to lengthen slightly.
In order to re-tighten them, it is sufficient to use the two tensioners situated on either

side of the machine, remove the side panels and then adjust the tensioners so that
the ironing belts have sufficient contact with the cylinder to correctly drive it without
jerking, even with the laundry.
Attention: carry out an identical tension on each of the 2 tensioners, in order to check the
symmetry of this adjustment; adjust the dimension between the bracket and
the belt tension nut, and this dimension must be identical on either side of the
machine. On Ø32 and 20, count the number of holes on the tension cog, as
this number must be identical on either side of the machine.
Take care not to stretch the belts too much, because they would run the risk of wearing very
quickly.
 Check the support of the pressing roller which must not compress the cylinder too
much, but be well above in order to give good ironing quality, its role being the
finishing of the laundry.
Attention: perform an identical tension on each of the 2 tension springs, in order to check
the symmetry of this adjustment; check the dimension between the bracket and
the hooking hole of the spring on the threaded rod, and this dimension must be
identical on either side of the machine.
On Ø32 and 20, count the number of holes on the tension cog, as this number must be
identical on either side of the machine.
DOC MACHINE Ø50.0-EN by PS on 19/06/2015, Page 29 of 33