grandimpianti C 200/51 Instructions Pour L'installation Et Mode D'emploi page 48

It is obligatory to install a check valve system for each of the machines before

reaching the header manifold.
 The connections must be Y-shaped; never T-shaped.
Increase the section before connection so that the final section is the sum of the two

previous ones.
Assembly and installation process
In order to be able to take the machine through a door of 0.90 metres, the tubs must be taken
out. In order to do this, proceed as follows:
Unscrew the 4 screws located inside the tub. Remove the tub.

Simply take out the input tub by removing it from its casing (pay attention to the guiding
springs fixed at the top).
Attention: take care not to let go of the handle on the panel to the right.
 Level the machine correctly.
Remove the top panel, loosen and then take out the screws and the red U-shaped

flanges used to wedge the cylinder.
Note: keep the screws and flanges for subsequent servicing.
Transport
flange
DOC MACHINE Ø50.0-EN by PS on 19/06/2015, Page 14 of 33