grandimpianti C 200/51 Instructions Pour L'installation Et Mode D'emploi page 45

Rates calorie output: in KW
Type 2000
40
The marking plate of this apparatus is situated at the top of the electricity cupboard to the
left of the machine.
2.2 Installation
Attention: the machine must be installed, regulated and started up only by a team
of technicians or retailers authorised by our company.
Likewise, the presence of the client is strongly recommended, particularly for positioning the
machine and the first tests.
The apparatus must be installed in accordance with currently applicable regulations and in
well ventilated premises.
In order to achieve the machine's optimal performance levels, you must ensure that fresh air
penetrates from outside the room, as close as possible to it.
The section of the fresh air intake must be at least 4 times that of the section of the output
pipe. Please note: the section of fresh air intake is equivalent to the section through which
the air can flow without resistance due to the grille installed at the entrance itself. Remember
that the bars of the grille often occupy a large part of the section of the grille.
The flow of new air required in cubic metres per hour for the combustion air supply is as follows:
TYPE
FLOW (cubic metres/hour)
Handling and unpacking
Upon delivery, the machine must be in a perfect state, and the packaging must be
complete with no signs of wear. Observe the indications shown on the packaging
(for example fragile, this way up, keep dry etc.). As the machine is large and quite
heavy (see below), appropriate hoisting and handling equipment must be provided
to ensure safe operation.
The machine must be handled with the aid of a fork-lift truck of sufficient capacity, with forks
as far apart as possible to avoid tipping.
It is essential to take the machine from the centre (centre of gravity in the axis).
Do not overturn or cause the machine to fall, for example during unloading.
Note: if slings are used (not provided) the machine will be handled entirely at the
unpacker's risk of deforming the machine).
type 2600
55
DOC MACHINE Ø50.0-EN by PS on 19/06/2015,
2000 2600
80 110
type 3300
69
3300
138
Page 11 of 33