grandimpianti C 200/51 Instructions Pour L'installation Et Mode D'emploi page 42

When the laundry is placed flat on the table at the front of the machine, it is automatically
taken to the drying and ironing cylinder by means of the nomex-polyester belts.
Then, a first hot press takes place by feeding the laundry through the press roller cover, at
constant pressure and self-regulated according to the thickness of the laundry by a
compensating spring system.
'Nomex' quality belts and a heating cylinder carry out the drying and ironing.
The tension of the belts is adjustable by means of planetary gear wheel and bearing with
guiding rails and tension springs.
Once it is dry and ironed, the laundry is naturally directed towards the receiving tray by means
of stainless steel spring strips (very gentle friction and spring quality maintained at +250°C),
and these strips are prolonged by teflon plates to avoid any marks on the strips.
So, the laundry comes out dry, ironed and perfectly pressed for immaculate appearance and
presentation.
1.4 Safety
User-activated safety
The operator's safety is assured by a plate situated just after the input table, thus

preventing the operator's hands from going too far. Light contact on this safety plate
causes the machine to immediately stop. This plate is the main emergency stop of
the machine (useable over the entire length).
 A second emergency stop (to the left of the machine) is very close to the operator,
thus allowing him to stop the machine at any time.
Safety linked to heating
The electronic temperature regulator assures the temperature regulation of the ironing
cylinder (for machines heated by gas and electricity only) below the over-heating limits of the
belts (heating cut off at 180° maximum).
A safety thermostat (at 190°) cuts off the heating in the case of breakdown of the electronic
regulator.
Safety linked to the gas heating system
If a fault of the gas system assembly appears, this gives rise to the gas supply being cut off
and the AL6 alarm appears on the display.
Once the alarm sound has ended, you can then reset the system by pressing + and – at the
same time (see alarm section). If the fault persists, one of the follow defects has occurred:
 No gas input: check that the gas input valve is open.
Deficient lighting electrode: change it.

 Exhaust flue of burned gases closed: check the draught.
DOC MACHINE Ø50.0-EN by PS on 19/06/2015, Page 8 of 33