grandimpianti C 200/51 Instructions Pour L'installation Et Mode D'emploi page 57

Programming of the operating temperature
The regulation temperature may be programmed with the machine on, as follows:
Press the SET button

The latest programmed value flashes on the display.
Use the + and - buttons to adjust the setting. By continuing to press the button, the

figure quickly goes up or down.
After 3 seconds of release of + or -, the indicated value is stored and the display returns to
the detected temperature.
Programmable interval:
Resolution:
The maximum value programmable by the user (Tmax) is established in the factory or during
installation by a particular procedure. See "Programming of parameters".
In the heating version by a unit of resistors, in order to limit the inertia of the system a special
device makes it possible to obtain a regulation around the indication point of above or below
5°C.
This turns the heating contactor repeatedly on and off upon approaching the set temperature.
It is therefore normal, with this type of heating, to repeatedly extend the engagement of this
contactor without adversely affecting its satisfactory operation.
SET
0...Tmax °C (32...Tmax °F)
1°C
DOC MACHINE Ø50.0-EN by PS on 19/06/2015, Page 23 of 33