Connection To The Pump - Agilent Technologies TV 902 Navigator Notice De Mode D'emploi

Connection to the Pump

Also the pump cable is shielded and is equipped with ferrite (see the
following picture). Pump cable length must not exceed 1.5 m.
The turbopump is connected to the controller through an 8-pin
connector. Pins B, C and D are the 3-phase supply to the motor, pin E
is connected to the pump ground, pins G and H are not connected,
pins A and F reserved for Agilent.
TV 902 Navigator User Manual / 87-900-999-01
Technical Information

Connection to the Pump

(B)
17
269/276