Operation; Switching On The Hob And Setting The Power; Switching Off The Hob; Residual Warmth Indicator - ETNA T302ZT Notice D'utilisation

OPERATION

Switching on the hob and setting the power

Switching off the hob

Residual warmth indicator

Boost

The power has 9 settings. There is also a 'boost' setting, which is
indicated by a 'P' in the display.
• Put a pan on a cooking zone.
• Touch the on/off button.
The display for this cooking zone will show '0.'. If no further action
is taken, the cooking zone will automatically switch off after a few
seconds.
• Use the + button or the - button to choose the correct setting. The
hob will automatically start in the chosen setting (if it detects a pan).
Tip
You can touch and hold the + or the - button to set the desired power
faster.
Touch and hold the on/off button to switch off the cooking zone
immediately.
A cooking zone that has been used intensively will retain heat for
several minutes after it has been switched off. An 'H.' will blink in the
display as long as the cooking zone is hot.
The 'Boost' function is used to cook at maximum power for a short
period of time (maximum 10 minutes). The power is reduced at the end
of the maximum boost time. Only switch the hob on at setting boost if
you want to boil water. This setting is too high for heating butter or milk
and much too high for defrosting.
Switching on the boost function
• Put a pan on a cooking zone.
• Touch the on/off button.
The display for this cooking zone will show '0'.
• Touch the - button one time to choose the boost setting at once.
EN 11