Power Settings; Two Cooking Zones Behind Each Other; Switch-Off Timer - ETNA T302ZT Notice D'utilisation

OPERATION

Power settings

Two cooking zones behind each other

Switch-off timer

EN 12
The power, depending on the diameter of the zone, is adjustable
between 50 and 2300 Watts. See the table below.
Diameter Power setting
Ø 160 mm 50 - 2000 W
Ø 180 mm 50 - 2300 W
Ø 210 mm 50 - 2300 W
• Two cooking zones one in front of the other are operated by one
generator. The advantage of this is that a high power level can
be realised for a cooking zone. This is ideal for bringing food and
liquids to the boil very quickly, for frying and for searing large
quantities.
• The generator divides the power between both zones. Up until
setting 5, this has no consequences. However, if a higher setting is
used then the other cooking zone will automatically be restricted.
• If you set one of the zones to a higher level then you must first
switch the other zone to a lower setting.
• Maximum combinations
1st zone 5
2nd zone P
• Two cooking zones that are beside each other do not influence
each other. You can set both cooking zones to a high setting at the
same time.
You can use the switch-off timer to switch off one of the cooking zones
automatically. The timer can only be used for a cooking zone that is in
operation. The 4 timers can be used together.
• Use the timer button to choose the cooking zone that must be
switched off. A light indicates the cooking zone to which the timer
is or can be linked.
• Press the timer button repeatedly to select the correct zone. The
timer can be linked to an arbitrary cooking zone.
9 P
9 5