ETNA T302ZT Notice D'utilisation page 97

TROUBLESHOOTING
Symptom
The hob is not working
and nothing appears in the
display.
A fuse blows as soon as the
hob is switched on.
The hob only works on one
side.
Continuous beep.
The hob simply switches off.
The hob does not work and a
fault code F1, F2, F3, F4, F5,
F6 or F8 is displayed.
The hob does not work,
the information or
displayed.
The hob switches off
during use and is beeping
approximately every
10 seconds.
A series of small or F7 is
displayed.
Error code F0.
Error code F9.
Possible cause
There is no power supply
due to a defective cable or a
faulty connection.
The hob has been wrongly
connected.
The hob has been wrongly
connected.
The hob has been wrongly
connected.
You accidentally touched a
On/Off button.
The electrical circuit works
poorly (temperature sensor
defect).
The hob is locked.
is
Something has boiled over
or there is an object on the
operating panel.
The electronic circuits are
warm.
Temperature of the
environment is too low.
Main voltage too low.
Solution
Check the fuses or the
electric switch (if there is no
plug).
Check the electrical
connections.
Check the electrical
connections.
Check the electrical
connections.
Switch the hob back on.
Contact the service
department.
See page 13 and 14; Child
lock.
Clean the hob or remove the
object and then continue
cooking.
See chapter on installation.
Increase the environmental
temperature.
Check the electrical
connections.
EN 19