Publicité
CHK
CONTROL SYSTEM
ADJ
2
1
a
ADJUSTING THE DASH-POT
Check:
•
Dash-pot operation
Engine stalls when quick decelera-
tion → Adjust.
Adjustment steps
(1) Install the tachometer onto the spark
plug lead of cylinder #1.
Tachometer
YU-08036-A/90890-06760
(2) Start the engine and allow it to warm
up for several minutes.
(3) Keep the engine speed at 3,750 ± 50 r/
min.
(4) Turn the adjust screw
pot plunger is just touching the lever
2
.
Locknut
18 Nm (1.8 m
(5) Close the throttle and stop the engine.
(6) Remove the tachometer.
NOTE:
Dash-pot adjustment should be carried on
after adjusting the carburetor.
START-IN-GEAR PROTECTION DEVICE
ADJUSTMENT (MHD, WHD)
1. Check:
•
Start-in-gear protection device oper-
ation
Incorrect → Adjust.
2. Adjust:
•
Start-in-gear protection device cable
Adjustment steps
(1) Set the shift lever in the neutral posi-
tion.
(2) Lossen the locknut
(3) Adjust the start-in-gear protection dev-
a
ice cable adjusting nut
point on the wire connector
with the mark
(4) Tighten the locknut.
3-11
1
until the dash-
kgf, 13 ft
lb)
•
•
1
.
2
so that the
3
aligns
a
on the flywheel cover.
E
Publicité
Chapitres
