Setting The Modbus Parameters; Ups Test - LEGRAND KEOR HP Série Manuel De L'utilisateur

Setting all the parameters
To save all the parameters it is necessary to reach the end of the guided procedure
until the last screen previously shown.
If the procedure is interrupted earlier, none of the parameters previously set will be
saved.
6.5

SETTING THE MODBUS PARAMETERS

The parameters regarding the communication via RS485 interface can be set in the
MODBUS menu.
 Modbus address
MODBUS ADDRESS
202
Parameter
MODBUS ADDRESS
6.6

UPS TEST

The UPS TEST menu allows to carry out a switching test of the inverter. The inverter is
switched off and the load is transferred to the bypass supply. The inverter supply is
automatically restored after a few seconds.
UPS TEST?
NO
UPS TEST?
YES
SPECIAL
UPS TEST
Possible loss of supply
In case of power failure while the test is being performed, the immediate operation of
the inverter is not guaranteed.
Manuel de l'utilisateur de l'UPS
The single digits can be modified via the arrow
keys (
(ENTER).
Standard Range
1 1 .... 247
The value on the second line is ready to be
changed
(1x)
The parameter is changed. The change is
confirmed by pressing
The system performs a test and returns to the
previous screen
UPS user manual
Utilizzo dell'UPS
/ ) and confirmed by pressing
(ENTER)
OMD10074 REV. C 31