Spartherm Mini R1V 51 Notice D'utilisation page 33

OVERVIEW INSTALLATION INSTRUCTIONS // SPARTHERM FIREPLACE INSERTS
Preface - Quality Philosophy
1. General notes
1.1. Certified quality
1.2. Installation steps
2. Basic requirements for setting up an
open fireplace
3. Locations and combustion air supply
3.1. Basic requirements of locations for open fireplaces
and prohibited locations
3.2. The operation of open fireplaces is not
hazardous if...
3.3. Open fireplaces may not be installed...
3.4. Combustion air supply
3.5. Combustion air flue
4. Cutoff device in the vent
4.1. Throttle device
5. Fire prevention in front of the combustion
chamber opening
5.1. Floors
5.1.1. Special measures for fire prevention when
floor covering is near the fire
5.2. Load-bearing structural elements made
of concrete and reinforced concrete
5.2.1. Special measure for fire prevention for adjacent,
combustible structural elements
Page 2 5.3. Wooden beams
5.4. Insulation layers
Page 4 5.4.1. Thermal insulation material thickness
Page 5 (e.g. rock wool pads)
5.4.2. Stud wall for walls that need protection
5.5. Special measure for fire prevention for
Page 6 hardwood mantels
5.6. Flexible grouting between facing and insert
5.7. Fireplace hood
Page 6 5.8. Connecting piece
5.9. Heat dissipation
5.9.1. Warm air heating systems
5.9.2.Closed fireplace units
Page 7 6. General installation notes
7. Special fire prevention measures
Page 8
8. Cleaning open fireplaces
Page 8 9. Special notes on Spartherm fireplace inserts
9.1. Flue gas neck tube
9.2. Spartherm fireplace inserts with sliding doors
Page 9 9.3. Carrying aids
Page 10 10. Technical data for fireplace inserts
GB 3
Page 11
Page 12
Page 13
Page 14
Page 15
Page 15
Page 16
Page 16
Page 17