Interruption Of Work Till 4 Hours; Taking Out Of Operation And Cleaning - WAGNER WOOD & METAL SPRAYER W 300 Mode D'emploi

GB

14. Interruption of Work till 4 Hours

•
Turn the machine off.
•
Insert the spray gun into the gun holder.
•
When processing 2-component varnishes, clean the device immediately.

15. Taking Out of Operation and Cleaning

Proper cleaning is the prerequisite for problem-free operation of the paint application
device. No warranty claims are accepted in case of improper or no cleaning.
1) Turn the machine off. Vent the container in case of longer breaks and after the work
has been terminated. This can be done by briefly turning open and then closing the
container or by pulling the trigger guard and letting the paint into the original paint
container.
2) Divide the spray gun. Press the hook (Fig. 5 "click") slightly downwards. Turn the gun
front part and gun rear part against each other and take them apart.
3) Unscrew the container. Empty any remaining coating material back into the material tin.
4) Preclean the container and feed tube with a brush. Clean the ventilating bore (Fig. 14, C).
5) Pour solvent or water into the container. Screw the container back on.
Do not use flammable materials for cleaning purposes.
6) Assemble the gun again (Fig. 5).
7) Turn on the machine and spray the solvent or water into a container or a cloth.
8) Repeat the above procedure until the solvent or water emerging from the nozzle is clear.
9) Turn off the machine and divide the spray gun. Press the hook (Fig. 5 "click") slightly
downwards. Turn the gun front part and gun rear part against each other and take
them apart
10) Screw of the container and empty it. Pull out the suction tub with container seal.
CAUTION! Never clean seals, diaphragm and nozzle or air holes of the spray gun
with metal objects.
The ventilation hose and diaphragm are only solvent-resistant to a limited
extent. Do not immerse in solvent, only wipe.
11) Pull the ventilating hose (Fig.10, 14) at the top from the gun body. Screw off the valve
cover (15). Remove the diaphragm (16). Clean all the parts carefully.
12) Unscrew the union nut and remove the air cap and nozzle. Clean the air cap, nozzle
seal and nozzle with a brush and solvent or water (Fig. 11).
13) Clean the outside of the spray gun and container with a cloth soaked in solvent or water.
14) Assemble the parts again (see "Assembly").
Assembly
The unit may only be operated with an integer diaphragm (Fig. 10, 16).
1) Place the diaphragm (Fig. 10, 16) with the pin facing upwards on the bottom section
of the valve. Also see the marking on the gun body.
2) Place on the valve cover (Fig. 10,15) and screw it closed.
24
W 300