Setting The Ringing Tone Volume - switel TE16 Mode D'emploi

Redialling
Your telephone stores the last phone number dialled. If you want to dial a number
again, e.g. because the connection was engaged or the call was not taken, use the re­
dialling function:
è
j
The phone number stored is automatically dialled.
Displaying the duration of a call (CLIP)
A few seconds after a call has begun, the current duration of the call appears in the dis­
play in minutes and seconds.
Caller number display (CLIP
The caller number display (CLIP) is a supplementary service offered by
your telephone network provider. The caller's number appears in the dis­
play if the service is offered by your telephone network provider. Contact
your network provider for further information.
If this function is available with your telephone line, the number of the caller appears in
the display when the phone rings. If the caller has suppressed transmission of his/her
phone number, the corresponding message appears in the display. The phone number
is not displayed and, as a result, is not stored in the call list.

Setting the ringing tone volume

You can change the volume of the ringing tone.
Move the sliding switch on the underside of the base unit to position "LO" for a quieter
ringing tone and to "HI" for a louder ringing tone.
Putting a call on hold
After putting a call on hold, the caller hears a melody and can no longer hear you.
Press the h button during a call to switch the function on and off.
1 CLIP: Calling Line Identification Presentation = Display the caller's phone number.
1
)
51
52
Operation
Lift the receiver
Press the button, dial the number
67