Mains Connection - Güde WS 230-2350 R Traduction Du Mode D'emploi D'origine

Additional Safety and Working Instructions
When grinding metal, flying sparks are produced.
Take care that no persons are endangered. Because
of the danger of fire, no combustible materials
should be located in the vicinity (spark flight zone).
Do not use dust extraction.
Avoid flying sparks and sanding dust hit your body.
Never reach into the danger area of the machine
when it is running.
Chips and splinters must not be removed while the
machine is running.
Immediately switch off the machine in case of con-
siderable vibrations or if other malfunctions occur.
Check the machine in order to find out the cause.
Do not let any metal parts reach the airing slots -
danger of short circuit!
Under extreme conditions (e.g. smooth-grinding
metals with the arbour and vulcanized fibre grinding
wheel), significant contamination can build up on
the inside of the angle grinder. For safety reasons,
in such conditions the inside should be cleaned
thoroughly of metal deposits and a motor circuit-
breaker must be connected in series. If the motor
circuit-breaker trips the machine must be sent for
repair.
For accessories intended to be fitted with threaded
hole wheel, ensure that the thread in the wheel is
long enough to accept the spindle length.
Always use and store the cutting and grinding disks
according to the manufacturer's instructions.
Always use the correct guard for cutting and grin-
ding.
Always use guard with cutting guide from the acces-
sories range for cutting stone.
The adjusting nut must be tightened before starting
to work with the machine.
Always use the auxiliary handle.
The workpiece must be fixed if it is not heavy enough
to be steady. Never move the workpiece towards the
rotating disk by hand.
STARTING CURRENT LIMITER
The starting current for the machine is several times
greater than rated current. The starting current
limiter reduces the starting current to such an extent
that a fuse (16 A, slow-blow) is not tripped.
SMOOTH START
Electronic smooth start for save use prevents jerky
run-up of the machine.

Mains Connection

Operation is only allowed with a safety
switch against stray current (RCD max. stray
current of 30mA).
Connect only to single-phase AC system voltage as
indicated on the rating plate. It is also possible to
connect to sockets without an earthing contact as
the design conforms to safety class II.
Only plug-in when machine is switched off.
Maintenance
Unplug the machine before any work on it.
Repairs and works specified in these Instructions may
only be performed by qualified authorised staff.
Use only original accessories and original spare parts.
Keep the device, in particular the air vents, clean at all
times. Never spray water on the device body!
Do not clean the plastics with solvents, flammable or
toxic fluids. For cleaning, use a damp cloth only.
Caution! If the power cord of the appliance gets
damaged, it must be replaced by the manufacturer or
its customer service or a similarly qualified person to
avoid danger.
Only a regularly maintained and treated appliance
can serve as a satisfactory aid. Insufficient mainte-
nance and care can lead to unforeseen accidents and
injuries.
If necessary, a list of spare parts can be found at www.
guede.com.
ENGLISH
17