Sirius Satellite Radio Operations; Channel Selection - Clarion VX400 Mode D'emploi Et Manuel D'installation

Sirius Satellite Radio Operations

This function is available when a Sirius Satellite
Radio Receiver is connected through the
dedicated connection.
This unit is recommended to be used with the
following receiver:
SIRIUS Satellite Radio Receiver: SC-C1
Note:
SIRIUS satellite radio is a subscription service.
Please contact Sirius Radio to begin or alter
your subscription:
• Internet: www.sirius.com
Telephone: 888-59-SIRIUS (747487)
Selecting a Satellite Radio Mode
Press the [SIRIUS] key on Main Menu display.
The system changes to the Sirius Satellite Radio
mode. The Sirius mode screen is displayed.

1
11
10
9
1 - Band key
 - Satellite Signal
 - Eject key
4 - Main Menu key
5 - Key Pad key
6 - Tune Up key
7 - Tune Down key
Information Displayed During Reception
The following information is displayed when the
satellite radio cannot be received normally.
• When the receiver is turned on the first time or
after a reset: "UPDATING" followed by a
percentage of completion.
• When a channel is being tuned in (no signal is
yet received): "ACQUIRING SIGNAL"
• A channel without a broadcast has been
selected: "INVALID CHANNEL"
• A channel not covered by your contract:
"CALL 888-539-SIRIUS"
Call (888) 59-747487 to activate your radio.
• When a channel is out of air time: "OFF AIR"
• When the antenna is disconnected or has
been damaged: "ANTENNA ERROR"
1
 4 5
6
7
8
1
8 - Audio Settings key
9 - List key
10 - Fast Backward key
11 - Fast forward key
1 - Media Information
1 - Sirius Channel
Information
Confirming Your Radio ID
1. Touch the [KEY] key on the SIRIUS Menu
display to display the keypad.
Enter "0" and press "OK".
Your SIRIUS ID (1-digit number) will be
displayed.

Channel Selection

1. Touch the [List] key on the SIRIUS Menu
display to enter channel list preview mode.
. Select the channel with the [
Only channels that can be received are
selected.
Channels that are locked and channels not
covered by the contract will be skipped.
The receiver seeks the next available channel
below or above the current channel.
Channel Selection with the Channel Number
1. Touch the direct access [Key] on the
SIRIUS Menu display to enter direct channel
selection.
. Enter the channel number of your desired
station by touching the [0] to [9] keys.
. Touch the [OK] key to tune the selection.
If you enter a wrong number, you can cancel
it by touching the [BACK] key.
] or [ ].
Seek Seek
9
VX400/VZ400