Removing The Se-B* Motor Protection Device - Bitzer CM-RC-01 Instructions De Montage

3.2 Removing the SE-B* motor protection device

KW-232-1
• Loosen the screws on the cover of the com-
pressor's terminal box and remove the cover.
• Then unscrew the protective earth conductor
from the terminal box cover.
Dismount the SE-B* motor protection device
from the terminal box.
• Pull the orange motor PTC cable off the ter-
minal plate.
• Then loosen the fixing screws of the motor
protection device and remove the device.
• Put the CM-RC-01 compressor module onto
the terminal box.
• Guide the orange motor PTC cable of the
compressor module downward through the
opening in the module housing and connect it
to the terminal plate of the compressor.
• Then guide the protective earth conductor of
the compressor upward into the module hous-
ing through the opening provided in the hous-
ing.
5