Connecting The Oil Heater; Mounting The Discharge Gas Temperature Sensor - Bitzer CM-RC-01 Instructions De Montage

3.3 Connecting the oil heater

3.4 Mounting the discharge gas temperature sensor

After mounting new components such as discharge gas
temperature sensor, pressure transmitter, injection
nozzle or injection valve:
6
• Properly position the compressor module on
the terminal box. The long side that is
provided with the numerous cable bushings of
the compressor module must point in the dir-
ection of the suction gas valve.
• Screw the protective earth conductor onto the
module housing.
• Put the oil heater cable through a screwed
cable gland on the compressor module and
connect it to the CN4 terminal strip.
• Guide the oil heater cable to the compressor
module as shown in the figure.
Information
For oil heater mounting, see Technical
Information KT-150.
WARNING
Serious injuries are possible. New component
may suddenly become detached.
Check the thread.
Carefully screw in the new component. Observe
the tightening torques!
Perform a tightness test before commissioning!
KW-232-1