Product Warranty - Redmond RMC-M4502FR Manuel D'utilisation

VII. BEFORE ADDRESSING A SERVICE CENTER
Error code
System error; system board or heating element
Е1- Е3
malfunction.
Problem
The unit does not switch on.
The meal is taking too long to
cook.
VIII. PRODUCT WARRANTY
We warrant this product to be free from defects for a period of 2 years from the date of purchase. If the appliance fails to operate properly within
the warranty period and is found to be defective in material or workmanship, we will repair or replace it free of charge. This warranty comes into
force only in case an original warranty service coupon with a serial article number and an accurate impress of the company of the seller proves the
purchase date. This limited warranty does not cover damage caused by the failure to use this product for its normal purpose or in accordance with
the instructions on the proper use and maintenance of the product or any kind of repair works. Do not try to disassemble the device and keep all
package contents. This warranty does not cover normal wear of the device and its parts (filters, bulbs, ceramic and Teflon coating, rubber parts etc.).
Service life and the applicable product warranty period start on the date of purchase or the date of manufacture (if the purchase date cannot be
established).
You can determine manufacture date by serial number, located on the identification label on the housing of the device. The serial number consists
of 13 digits. 6th and 7th digits of the serial number identify the month, 8th digit the year of manufacture.
Service life of the product, established by the manufacturer is 5 years from the date of purchase, provided that the unit is used and maintained in
accordance with the user manual and applicable technical standards.
The packaging, user manual and the device itself may not be treated as household waste. Instead, it shall be taken to the applicable collection point for
the recycling of electrical and electronic equipment.
38
Error description
Unplug the device and let it cool down. Close the lid tightly and plug it back in. If this does not
eliminate the error, address an authorized service center.
Possible Cause
Voltage supply failure.
Voltage supply interruption.
The bowl is installed with a distortion.
There is a foreign object between the bowl and the heating
element.
The heating element is dirty.
Error handling
Solving the problem
Check the voltage supply.
Check the voltage supply.
Install the bowl properly.
Remove the foreign object.
Unplug the device and let it cool down. Clean the heating element.