Troubleshooting; Troubleshooting The Sauna Heater - Tylo SENSE SPORT Notice D'utilisation

TROUBLESHOOTING

Troubleshooting the sauna heater

Table 1: Troubleshooting the sauna heater
Symptom Possible cause
Heater is not work- Thermostat is not
ing. set high enough.
Timer is not in the
range correspond-
ing to ON.
Heater is not work- Fuses in the distri-
ing. bution board have
blown/tripped.
Heater is not work- Internal temperat-
ing. ure cut-out activ-
ated. For more de-
tails, see The sec-
tion called Temper-
ature cutfunction,
Page 5.
The fuses/earth The heater has re-
fault breaker in the mained inactive for
distribution board a long time, causing
trip as soon as the an insulation fault
heater is turned on in the tubular ele-
or during operation. ments.
Temperature cutfunction
The temperature cut-out in the heater has the purpose of protect-
ing the components, tubular elements and woodwork in the sauna
from overheating. If the temperature cut-out is triggered, it must
be reset before the heater can be turned on again. The cause of
the overheating must be established before resetting the temper-
ature cut-out.
Remedy
Raise the thermo-
stat setting.
Raise the time set-
ting, but not higher
than 3 hours.
Replace/reset the
fuses in the distribu-
tion board that have
blown/tripped.
Check and remedy
the cause of tem-
Figure 8: Resetting the temperature cut-out
perature cut-out ac-
tivation.
Resetting the tem-
perature cut-out.
There is a red but-
ton under the heat-
er which can be
pressed in (see Fig-
ure 8, Page 5).
Switch off the heat-
er and do not use
it. Contact an elec-
trician to check the
fault, or contact the
dealer during the
guarantee period.
5