Maintenance; Cleaning The Fragrance Holder And Air Humidifi Er; Check The Stone Compartment; External On/Off Switch (Option) - Tylo SENSE COMMERCIAL Notice D'utilisation

8

MAINTENANCE

Cleaning the fragrance holder and air humidifi er, Commercial
6-8
Clean the fragrance holder and air humidifi er as required.
To clean the fragrance holder and air humidifi er:
Remove the fragrance holder/air humidifi er and rinse them under
running water.
Figure 6: Cleaning the fragrance holder and air humidifi er, Com-
mercial 6-8

Check the stone compartment

Check the stone compartment at least once annually or as many
times per year as the heater is used per week.
Example: If the unit is used 3 times a week, check the stone
compartment 3 times per year.
WARNING! If the stone compartment fi lls up with
gravel and small stones, the tubular element can be
damaged as a result of overheating, as air fl ow will
be insuffi cient.
How to check the stone compartment:
1. Remove all stones from the compartment.
2. Remove any small stones, gravel and limescale from the
compartment.
3. Put whole, undamaged stones back. Replace damaged sto-
nes with new ones as required (see Filling the stone compart-
ment, page 6).

EXTERNAL ON/OFF SWITCH (OPTION)

External ON/OFF switch can be installed anywhere outside the
sauna. The switch works for impulse or constant deactivation.
The heater circuit automatically recognises which is used. Heater
status and faults on the door contact can be seen if the switch has
a built-in LED.
See instructions supplied with the control panel.

DOOR CONTACT (OPTION)

The door contact is necessary to be able to use the Pure panel's
preselected time or the Elite panel's calendar function, plus remo-
te control the sauna via external switch, mobile or PC apps.
See instructions supplied with the control panel.

TROUBLESHOOTING

The temperature cut-out
The temperature cut-out in the heater is there to protect the
components, pipe elements and woodwork in the sauna from
overheating.
Commercial 6-8: There is a red reset button under the heater
which must be pressed in. If the cut-out has activated, the button
will feel stiff and will 'click' when reset. If the cut-out has not acti-
vated and after resetting, the button will feel springy.
Commercial 10-20: The sauna heaters have a temperature limit
control built into the terminal box on the heater. Call an expert to
reset the temperature limit control.
Information!
When the overheating cut-out activates, always check the cause
of the problem. The service life of the tubular elements can be
adversely eff ected by each overheating. Recurring overheating
can be an indication of the following: Ventilation defi cient? Room
volume? Internal heater fault?
Figure 7: Resetting the temperature cut-out (Commercial 6-8)

Troubleshooting the control panel

See instructions supplied with the control panel (Pure, Elite).