Fault Finding; Spare Parts List - SKF TMBH 1 Mode D'emploi

5.1 Fault finding
In case of certain malfunctions, the operator will be guided by an error code appearing on
the display:
Display Fault
E 00 E Electronic failure
E 01 E Electronic failure
E 02 E Electronic failure
E 03 E Overheating in housing
E 04 E Selected time / temperature out of range
E 05 E Temperature increase below
1 degree per 15 s.
E 06 E Temperature probe not connected or defect
E 07 E Temperature above 200 °C (392 °F)
E 08 E Clamp is open
E 09 E Clamp not plugged in or broken

6. Spare parts list

Designation
TMBH 1-1
TMBH 1-1A
TMBH 1-1B
TMBH 1-1D
TMBH 1-1E
TMBH 1-1F
TMBH 1-1G
TMBH 1-2
TMBH 1-2A
TMBH 1-3
TMBH 1-3A
TMBH 1-5
MP524
WORLDWIDE PATENTS
SKF TMBH 1
Description
Control box (complete)
Logic print
Power print
Housing cover (including keyboard foil)
Keyboard foil
Mains inlet connector (female Euro-connector)
Main switch
Heating clamp (including cable and plug)
Heating clamp plug set (male and female part)
Temperature probe (including cable and plug)
Temperature probe plug set (male and female part)
Heating pad
Instruction manual
Action
Return to SKF for repair
Return to SKF for repair
Return to SKF for repair
Wait for unit to cool down
Adjust time / temperature setting
Check that the probe is properly
attached to the workpiece or
change to TIME MODE
Check the prob
Stop heating
Close the clamp
Plug in or change the clamp
9