Assembly; Inserting/Removing The Hose; Inserting/Removing The Telescoping Tube; Mounting/Removing Suction Nozzles - Cleanmaxx AC-1107-3 Mode D'emploi

EN

Assembly

Unpacking the product contents
ATTENTION!
■ Risk of suffocation! Keep the packaging material away from children and animals.
■ Make sure that the device is not connected to the power supply before you attach or
remove any accessories.
Unpack all parts and make sure that the scope of delivery is complete (see chapter "Pro-
duct contents and device overview") and check for any damages from transport. If you
identify damages to the components, do not use them (!), instead contact our customer
service centre.

Inserting/removing the hose

Inserting/removing the telescoping tube

Adjusting the length of the telescoping tube

Mounting/removing suction nozzles

• Insert the open end of the telescoping tube in one of the enclosed suction nozzles
up to the stop. Turn the nozzle back and forth slightly in the process.
• The suction nozzles can also be attached directly to the suction hose without the
telescoping tube for more fl exibility.
22
• Insert the suction hose connector into the suction opening
on the device. It must audibly lock into place.
• To remove the suction hose push the knobs on the con-
nector and pull the suction hose out.
• Insert the open end of the handle into the corresponding
opening on the telescoping tube. In the process, turn the
handle back and forth somewhat. Check to make sure
that the connection is secure.
• To remove the telescoping tube pull it off of the handle.
• Push the slider on the telescoping tube down and set the
desired length.
• Release the slider and move the tube forward until it locks
into place.