Corghi HD 900 Manuel D'utilisation page 51

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

A
work.
DEMOUNTING
Tubeless tyres can be demounted in
two ways:
a- If the tyre demounts without difficulty, once
the beads have been broken, press the bead
breaker disc against the inner side of the tyre
until both beads come out of the rim (see fig.
21).
b- With SUPERSINGLE or very hard tyres the
procedure described above in point a cannot
be used. The hook tool must be used as follows:
- E
- Operator's manual HD 900
nglIsh
1) Move the tool holder arm to the outside of
the tyre.
2) Move the mobile control unit to work-
ing position C.
3) Rotate the wheel and at the same time move
the hook tool forward inserting it between the
B
20
rim and bead until it is anchored to the bead
(see Fig. 22).
4) Move the rim about 4-5 cm away from the
tool making sure the bead does not detach
from the tool.
5) Move the hook tool outward so that its red ref-
erence dot is moved near the external rim edge.
21
6) Move the mobile control unit to work-
ing position B.
7) Insert the lever (A, Fig. 22) between the rim
and the bead to the right of the tool.
8) Keeping the lever pressed down,
lower the wheel to bring the rim edge
A
22
51
UK

Publicité

Table des Matières
loading

Table des Matières