Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Increasing the air pressure
1.
Set the fork to "OPEN" mode (see "SETTING THE RIDING
MODE" from page 26).
2.
Unscrew the cover on the air side of the fork using the setup
tool (Torx T10) supplied in the RWS lever.
3.
Unscrew the dust cap.
4.
Screw on the shock pump and pump the fork up to the
required pressure.
Follow the instructions issued by the pump manufacturer!
5.
With the pump attached, slowly compress the fork twice by
about 10 mm and then decompress fully.
This equalises the positive and negative air chambers.
Once the pressure displayed on the shock pump stops changing after compression, the two air
chambers have equalised.
6.
Repeat steps 4 and 5 until the desired pressure is displayed on the shock pump after compression.
7.
Unscrew the shock pump and screw the dust cap onto the valve.
8.
Fit the cover and tighten the screw until it is hand-tight (max. 0.2 Nm) using the setup tool (Torx T10).
Reducing the air pressure
1.
Set the fork to "OPEN" mode (see "SETTING THE RIDING MODE" from page 26).
2.
Unscrew the cover on the air side of the fork using the setup tool (Torx T10) supplied in the RWS lever.
3.
Unscrew the dust cap.
SLOWLY
4.
press the valve insert with the back of the dust cap.
or
Screw on the shock pump and
the shock pump.
5.
With the pump attached, slowly compress the fork twice by about 10 mm and then decompress fully.
This equalises the positive and negative air chambers.
Once the pressure displayed on the shock pump stops changing after compression, the two air
chambers have equalised.
6.
Repeat steps 4 and 5 until the desired pressure is displayed on the shock pump after compression.
7.
Unscrew the shock pump and screw the dust cap onto the valve.
8.
Fit the cover and tighten the screw until it is hand-tight (max. 0.2 Nm) using the setup tool (Torx T10).
SLOWLY
reduce the air pressure by pressing the release valve on
25
Publicité
Table des Matières
