DT SWISS F 535 ONE Mode D'emploi page 22

3.7 FITTING THE REMOTE CABLE
1. Remove the cover (5) on the damping side using the setup tool (Torx T10) inside the lever of the RWS.
2. Put on the cable housing (2) and the cable adjuster (1).
• Only cable housings with an outer diameter of 4 mm must be used.
• Slide the cable housing through the cable holder on the backside of the fork crown (A).
• Before and after the cable adjuster (1) there must be at least one short piece of cable housing.
3. Switch the remote lever to position "OPEN" and insert the cable through the cable housing (2).
4. Place the cable around the remote wheel and clamp it with the clamping screw. Tighten the clamping
screw with a maximum torque of 1.3 Nm.
• The clamping screw must be positioned in one of the five holes so that the cable wraps around the
remote wheel as far as possible.
• The three driving modes "OPEN", "DRIVE" and "LOCK" must be freely adjustable.
• The end of the cable must not touch the incoming cable (3).
• The end of the cable must be cut as close as possible to the clamping screw.
• Do not use a cable end cap.
5. Adjust the cable.
• Switch to "DRIVE" mode using the remote lever.
• Check that the markings (4) on the remote wheel and the fork crown match.
If necessary, adjust the cable tension via the cable tension adjuster until both markings match.
6. Fit the cover on the damping side (5) and tighten the screw until it is hand-tight (max. 0.2 Nm) using the
setup tool (Torx T10).
22