Residual Risks - Modine ECO PCR 14 Manuel Technique

ENGLISH
SECTION 12

Residual risks

The equipment presents a number of risks that have not been fully eliminated from the design point of view or through
the installation of adequate protections. Based on such risks, it is reported which PPE (Personal Protection Equipment)
should be used by the operators or which behaviours and procedures should be adopted.
During installation of the equipment ensure sufficient space to limit these risks.
To preserve such conditions, the corridors and areas surrounding the equipment must always:
be kept free from obstacles (such as ladders, tools, containers, boxes);
•
be clean and dry;
•
be well lit if necessary.
•
List of residual risks that remain in relation to the equipment:
RISK
BURN
ELETTROCUTION
SHARP FINS
CUTTING AND CRUSHING BY BODIES IN MOTION
RISK OF FALLING
Headers can reach high temperatures, avoid contact.
Hot air from the fans can cause discomfort to personnel and damage to property.
Any use other than that specified in this manual is considered incorrect.
During operation of the equipment, no other types of work or activities are permitted that are to be considered as
incorrect and that in general may entail risks for the safety of persons and damage to property.
Predictable misuse will be considered:
failure to disconnect the power supply with the main switch in the open position "O" (or disconnecting of
•
the plug from the socket) before performing adjustment, recovery and maintenance operations;
insufficient maintenance and periodic checks;
•
structural changes or modifications to the operating logic;
•
tampering with the guards and safety systems;
•
www.modine.com
DESCRIPTION
The operator (in particular
maintenance) intentionally or unintentionally touches a
hot or frozen surface: if necessary use insulating gloves
and/or wait for cooling/heating of the surfaces.
Contact with live electrical parts during maintenance
operations carried out with the presence of voltage:
operations reserved for
operators, equipped optionally with PPE and insulating
tools - in general, turn off the power supply to the model
by placing the main switch in the open position "O" and
locking it in this position.
The operator at the stages of use and cleaning must be
careful of the fins and the edges as they are sharp.
The operator (in particular
maintenance) must pay attention to the fans. In general
disconnect the fan by placing the safety switch located
at the opening in the open position "O".
It is strictly forbidden to walk or climb on the unit, as it
can cause damages and create situations of risk of
falling.
situations or during
qualified and authorized
situations or during
40