Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
SECTION 4
Inspection – storage
1.
Upon delivery of the model immediately check its state of integrity; immediately dispute with the transport
company any damage. The packaging is created according to the model, to suitable means of transport and of
handling.
2.
The heat exchangers of the condensers are supplied with a pre-charge of dry air at 2 bar and have load
couplings of 1/4" SAE.
Check for the presence of pressure. In absence of pressure immediately contact the manufacturer and report
the problem on the transport document. Insufficient pressure indicates a loss due to a damage incurred during
transportation.
3.
The model must be stored in its original packaging in a temperate place protected from weathering.
4.
Do not place any other material on top of the packaging.
5.
The following rules apply when the model must remain in storage for long periods of time.
The model must be stored indoors and positioned according to its working position. This ensures functionality of
the drainage holes of the fans. With the model stored in a damp environment, it is necessary to examine the
outer covering to make sure that there are no damaged points. If any are found, please have them repainted.
The fans must be protected with plastic reinforced sheetings or with some other mechanical protection against
water and/or contaminants which could damage the motors.
The free surface of the finned pack must be mechanically protected with a panel or with something similar.
During storage-time, the fans must be manually rotated at least once every 3 months.
SECTION 5
Transport and handling
1.
When transporting and handling, be careful not to tilt the model. Danger of tipping over.
2.
During transport and handling of the packed model, do not exert improper pressure on the packaging, which
must always be kept in the position indicated by the overlaid graphics.
3.
When transporting and handling the packed model, use appropriate personal protection equipment (e.g. gloves
that are sufficiently resistant to mechanical hazards) to prevent injury with the packaging and model parts (e.g.
fins, bodywork).
4.
When transporting and handling the packed model, always pay attention to the correct distribution of weights in
relation to the lifting equipment used.
5.
The packed model must be moved by qualified personnel only, using one or more forklifts of suitable capacity or
a crane or overhead crane (see dimensional tables). In order to avoid overturning, the lifting brackets must be
longer than the depth of the packaging. Avoid any sudden movement and do not stand near the operation area.
It is essential to take all the necessary measures to ensure the complete safety of the operators in order to
avoid the accidental fall of the model upon people, it is forbidden to operate under a suspended load, it is
recommended to prepare a structure with a capacity greater than the weight to be supported (stand or props) on
which to place the model.
www.modine.com
26
Publicité
Table des Matières
