Modine ECO PCR 14 Manuel Technique page 28

ENGLISH
8. If the model is provided with support legs to be installed:
a. all operations on the model must be carried out by qualified personnel in accordance with specific design
conditions, local regulations and legislation.
b. take the packaged model as close as possible to the point of installation (see points 1 - 7 above).
c. unpack the model.
d. lift the unpacked model by securing it to the side lifting brackets (see diagram below).
e. install the supplied legs using the supplied screws and washers. Each leg must be fixed with 3 M8x20
screws and 3 M8 Øe18 conical knurled washers.
f. place the model on the installation point.
n. 4 support legs
n. 6 support legs
n. 8 support legs
www.modine.com
PCR14
PCR35
PCR55
Support legs installation scheme and position of lifting points.
PCR24 PCR25
PCR45 PCR46
PCR56 PCR66
PCR34
28