General Safety Instructions; Symbols Used - Burkert 1094 Instructions De Service

1

GENERAL SAFETY INSTRUCTIONS

To ensure that the devices function correctly, and that they have a long service
life, please comply with the information in these Operating Instructions, as well
as the Application Conditions and the permissible values that are specified in the
data sheets for the proportional valve used, and for the type 1094 electronic
system:
•
when planning the application of the device, and during its operation, observe the
general technical rules;
•
observe the relevant accident prevention and safety regulations applicable for
electrical equipment throughout the operation, maintenance and repair of the device;
•
note that lines and valves must not be disconnected from systems that are under
pressure; always switch off the voltage supply before working on the system;
•
take suitable measures to prevent unintentional operation or impermissible
impairment;
•
if these instructions are ignored, no liability will be accepted from our side, and the
guarantee on the device and on accessories will become invalid.
NOTE
2

SYMBOLS USED

In these Operating Instructions, the following symbols are used:
indicates a working step that you will have to carry out
ATTENTION!
NOTE
2 - 1094
Approvals such as Ex, UL, UR, CSA, DVGW etc., will be
indicated on the rating plate, or by a special label.
indicates information which must be followed. Failure to do
this could endanger your health or the functionality of the
device
indicates important additional information, tips and
recommendations