Console (Fig. E-1); External Connections; Buttons - Tunturi FitRun 90i PRO Manuel De L'utilisateur

English
WARNING
• Before pressing the circuit breaker, remove the
mains plug from the equipment.
If the equipment shuts down, proceed as follows to
restart the equipment:
- Remove the mains plug from the equipment.
- Press the circuit breaker to restart the equipment.
- Insert the mains plug into the equipment.
NOTE
• Some circuit breakers used in homes are not
rated for high inrush currents that can occur
when a treadmill is first turned on or even during
normal use. If your treadmill is tripping the circuit
breaker (even though it is the proper current
rating and the treadmill is the only appliance
on the circuit) but the circuit breaker on the
treadmill itself does not trip, you will need to
replace the breaker with a high inrush type. This
is not a warranty defect. This is a condition we as
a manufacture have no ability to control.
Unfolding and folding the
equipment (fig. F1-F2)
The equipment can be unfolded for use (fig. F1) and
folded for transport and storage (fig. F2).
Refer to the illustrations for the correct way of unfolding
and folding the equipment.
CAUTION
• Before folding the equipment, make sure that
the incline is 0%. If the incline is not 0%, folding
will damage the mechanism.

Console (fig. E-1)

CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is covered
with drops of sweat.
• Do not lean on the console.
NOTE
• The console switches to standby mode when the
equipment is not used for 10 minutes.
Press any key to wake up console again when
being in standby mode.

External connections

USB port
Usb port can be used for charging purposes only.
AUX port
Aux port can be used to connect an external media
device and play music over the build in speakers.
NOTE
• The console can only be used as speaker system,
and is not able to use as media player. You need
an extra device to use as a media player such as
a smart phone or tablet.
• When using the console speakers it might result
in HR reading problems.

Buttons

Start
- Start selected workout.
- Restart Paused workout when being in pause mode.
Stop
- Stop the active training, and reset al parameters.
Pause
- Press to pause workout at any time. "PAU" will be
displayed, and runnign data will be saved.
Incline up
- Increases the incline (0~15 ± 0,5).
- Pressing and holding will increase the incline faster.
- Change values in programming mode.
Incline Down
- Decreases the incline (0~15 ± 0,5).
- Pressing and holding will decrease the incline faster.
- Change values in programming mode.
Incline hot keys.
Incline Hot Keys are set as: 3, 5 & 7.
For example, the incline level changes from any level to
7 by pressing the Incline Hot Key 7.
Speed Up
- Increases the speed (0,8~20 km/h ±0,1km/h).
- Pressing and holding will increase the speed faster.
- Change values in programming mode.
Speed Down
- Decreases the speed (0,8~20 km/h ±0,1km/h).
- Pressing and holding will decrease the speed faster.
- Change values in programming mode.
2 6