Use And Operation - SOMFY AXOVIA 220B RTS Manuel D'utilisation

Axovia 220B RTS

3. USE AND OPERATION

3.1. Default operation in sequential mode
By default, the gate will operate in sequential mode.
3.1.1. Full opening mode with a 2- or 4-button remote
control
Press the programmed button to open the gate fully.
3.1.2. Pedestrian opening mode with a 2- or 4-button
remote control
Press the programmed button to open the gate in pedestrian mode.
Copyright © 2017 SOMFY ACTIVITES SA. All rights reserved.
STOP
STOP
3.1.3. Full opening mode with a 3-button remote control
3.1.4. Full pedestrian opening mode with a 3-button re-
mote control
3.1.5. Obstacle detection operation
When an obstacle is detected during opening, the gate will stop. Pressing
the programmed button on the remote control closes the gate.
If an obstacle is detected during closing, the gate will stop. Pressing the
programmed button on the remote control reopens the gate.
3.2. Operation in automatic closing mode
If automatic closing mode has been programmed during installation, the
gate will operate as follows:
Pressing a programmed button on the remote control will cause the gate
to open. The gate will close automatically a er 30 seconds.
If photoelectric cells are installed, any movement in front of the cells will
cause the gate to close automatically a er 5 seconds.
The gate can be held in the opened position by giving a stop command
during the time delay. To close the gate, press the remote control button
again.
EN
STOP
3