Set Display Backlighting (Lcd) - Seca 264 Mode D'emploi

Set display backlighting
64 •
Autoprint (APrt)
Length units (Unit)
NOTE
The wireless module is switched off when
factory settings are restored. Information about
existing wireless groups is retained. Wireless
groups do not have to be set up again.
1. Select the item "rSEt" from the menu.
2. Confirm the selection.
You will leave the menu automatically.
3. Switch off the device.
The factory settings are restored and are available
when the device is switched on again.
You can change the duration and brightness of the
display backlighting.
(LCd)
1. Select the item "LCd" from the menu.
2. Confirm the selection.
3. Select a menu item
– dUr: Duration
– bri: Brightness
4. Confirm your selection.
The current setting is displayed.
5. Select the setting you require.
Function
Duration
Brightness
6. Confirm your selection.
You will leave the menu automatically.
7. If you also wish to make settings for the second
function, repeat this process.
Function
• Short (approx. 15 Sek.)
• Long (approx. 45 Sek.)
• 50%
• 100%
• OFF
Factory setting
off
cm
Setting