Installing The Head Slide; Install The Third Column Element - Seca 264 Mode D'emploi

Installing the head slide

Install the third column
element
To position the head slide on the upright, proceed as
follows:
1. Tilt the head slide slightly towards the front.
ATTENTION!
Damage to device due to incorrect handling
Incorrect handling can damage the claw guide
of the head slide.
− Do not position the head slide on the column
element either vertically or tilted towards the
back.
− Do not apply any excessive force during the
installation.
2. Carefully position the tilted head slide on the
column element.
3. Straighten the head slide so that it stands vertically
on the column element.
4. Keep the brake button pressed and carefully push
the head slide onto the column element.
To connect the column elements, proceed as follows:
1. Screw a threaded rod hand-tight into the elongated
nut of the second column element.
2. Push the column element over the threaded rod
onto the upright connector of the second column
Element.
3. Position the end cap on the second column
element so that the threaded rod protrudes from
the hole of the end cap.
4. Place the plain washer on the free end of the
threaded rod.
5. Place the nut on the free end of the threaded rod.
6. Tighten the nut.
7. Place the decorative cap on the nut.
Before you get started ... • 51
English