Dust Filter; Retention System; Storing The Helmet; Accessories And Spare Parts - SCHUBERTH E1 Mode D'emploi

G. MAINTENANCE AND CARE

6. DUST FILTER

1. Take dust filter out from behind the chin ventilation.
2. Rinse out the dust filter with cold water and, if necessary, use a mild
soapy solution. Let the dust filter dry at room temperature.
3. Re-insert after drying.

6. RETENTION SYSTEM

The metal components of the retention system do not require maintenance.

7. STORING THE HELMET

Store the helmet in the helmet bag supplied in a dry, well-ventilated and
stable place. Always position the helmet so that it cannot fall to the floor.
Damage that occurs in this way is not covered by the warranty.
Note:
Store the helmet out of the reach of children and animals.
100
H. ACCESSORIES AND SPARE PARTS

1. COMMUNICATION SYSTEMS

Your E1 is supplied ready for installation of the SCHUBERTH
SRC-System™ as standard. The E1 is already fitted with two integrated
antennas to amplify reception and a Bluetooth
with the best possible radio reception.
You can find out more about the SRC-System™ from your specialist dealer
and at WWW.SCHUBERTH.COM
Integrated antennas for optimal
radio reception
Plug for connection with the
SRC-System™
Caution:
The installation of a communication system (including basic headsets)
constitutes a modification to the helmet. For this reason it is necessary
for any communication system and headset intended for installation
into a specific model of helmet to be tested and approved in line with
the ECE-R 22.05 European helmet standard, otherwise the helmet's
approval and compliance with insurance requirements become invalid on
installation.
® EN
connection, to provide you
®
Bluetooth antenna
101