SCHUBERTH E1 Mode D'emploi page 37

Masquer les pouces Voir aussi pour E1:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 55
C. THE HELMET
REPLACING THE VISOR SHIELD
Changing the face shield is easy to do without tools using the convenient
EasyChange mechanism. To do so, the shield must be dismantled. To replace
the face shield, it is helpful to place the helmet on a flat surface or
on your lap while seated.
Removing the face shield
1. Move the face shield into the
uppermost locked position.
2. Press the spring underneath the face
shield mechanism on one side towards
the face shield opening, then do the
same with the spring on the other side.
3. Move the face shield upwards until
it is released from the face shield
mechanism.
Installing the face shield
1. Using both hands, guide the
face shields locking studs into the
respective recesses in the face
shield mechanism.
70
2. The face shield will then audibly lock
into place when you press it gently
towards the helmet with a simultaneous
closing movement.
3. Make sure that the face shield
mechanism is functioning properly by
opening the face shield once to its
maximum extent.
ANTI-FOG LENS
Fitting
1. Lay the anti-fog lens in the face shield
in such a way that one side of it is
already slotted into the locking pin.
2. Now grasp the other side of the anti-
fog lens by its upper and lower
transverse edges and use your index
finger to gently press the end of the
visor into a slight "S" shape. Now you
can easily guide the slot over the
locking pin and release the anti-fog lens
into place.
EN
71

Publicité

Table des Matières
loading

Table des Matières