Inner Lining; Ventilation - SCHUBERTH E1 Mode D'emploi

Masquer les pouces Voir aussi pour E1:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 55
G. MAINTENANCE AND CARE
Tip:
Stubborn dirt on the outer surface of the face shield (e.g. dried-on
insect remains) can be easily removed by covering the closed visor
with a moist or wet cloth and allowing the dirt to soften for around
30 minutes to 1 hour.
Note:
Always avoid temperatures above 40 °C and high humidity when
choosing a place to store the face shield, as these conditions can cause
damage to the face shield.

4. INNER LINING

The inner lining of the E1 can be removed completely. The head and cheek
pads can be washed by hand using a mild soap solution (e.g. with highly
diluted standard mild detergent) at a maximum temperature of 30 °C. Allow
the lining to dry at room temperature and with good ventilation.
Tip:
If required (e.g. during a break in a journey), the headband can be hung
out to dry over the mirror.

5. VENTILATION

VENTILATION COWL
When necessary, the head ventilation system's air inlet cowl can be removed
to clean the ventilation mechanism.
1. Before cleaning the ventilation
mechanism, you must disassemble the
shield.
98
2. Move vent caps to the back as far as
they will go.
3. Grasp under the bottom edge of the
vent cap and remove it by moving the
lever toward the top.
4. Clean the vent cap and mechanism.
5. Set the pin for the vent cap to
match the connector system for the
ventilation mechanism precisely, and
to assemble insert the vent cap into
the assembly until an audible "click"
is heard. Please ensure that all four
mounting points are snapped in.
EN
99

Publicité

Table des Matières
loading

Table des Matières