Integrated Cleaning Programme - Melitta Caffeo CI Mode D'emploi

Cleaning parts of the milk system
It is recommended to clean the milk
container, milk distributor and the cover
of the front milk distributor regularly,
in addition to the intensive cleaning
programme.
• Disconnect the tube from the outlet.
• Flip open the outlet forwards.
• Pull the milk unit downwards in the
direction of the arrow and out of the
outlet (Image G).
• Remove the front cover from the milk
distributor (Image H).
• Rinse the individual parts with hot water.
• Reassemble the parts in reverse order.

Integrated cleaning programme

The integrated cleaning programme (takes
about 10 minutes) removes residues and
coffee oil residues that cannot be removed
by hand. The progress bar on the graphic
display 4 shows the current progress of
the cleaning programme.
The integrated cleaning programme
should be performed every 2 months or
after 200 brewed cups of coffee, at the
latest, however, when a corresponding
message appears on the graphic display
4.
Only use Melitta
®
• Flip up the lid of the water reservoir 6.
• Pull the water reservoir 6 up and out of
the appliance.
• Fill the water reservoir 6 with tap water
up to the max. mark.
• Reinsert the water reservoir 6.
• Connect the tube to the drip tray and to
the outlet (Image D).
• Call up the Care sub-menu.
• Select Cleaning in the menu.
• Select Start in the menu. The cleaning
programme starts.
BA_CI_042015.indd 33 BA_CI_042015.indd 33
cleaning tabs.
• Empty the drip tray and coffee grounds
container in between and reinsert them.
• If the message "Place a vessel with
0.7 l capacity under the outlet" appears
on the graphic display 4, place a
corresponding vessel under outlet 3.
• Two rinsing processes will be performed.
• If the message "Add cleaning tab to the
ground coffee chute" appears on the
graphic display 4, open the lid of the
ground coffee chute, throw in a cleaning
tab (Image I) and close the lid again.
• The cleaning programme will continue
(approx. 5 minutes), water fl ows out of
the outlet and in the drip tray inside the
appliance.
• When the message "Empty tray
and vessel" appears on the graphic
display 4, empty the vessel under the
outlet and the drip tray. Then reinsert
them both.
• After the cleaning programme is
fi nished, the appliance is ready for
operation.
33
20.04.2015 20:45:12 20.04.2015 20:45:12