TOOLCRAFT 2331524 Notice D'emploi page 63

• Now measure the three required lines. Refer to the following figure for the
correct order.
• The height is calculated automatically and the result will be displayed in the
main value display (E).
Press the C/OFF button (7) to delete the values. The measurement can be
•
repeated as often as desired.
o) Viewing/retrieving stored measurements
The last 30 measurement results are stored automatically. To view these
measurements, proceed as follows:
• Select the memory function. The
of the LCD display (10).
• Repeatedly press the buttons (5 or 8) to display the stored measurement
results.
• Press the C/OFF button (7) to exit the memory function and switch to individual
measurement mode.
p) Selecting the reference edge for a measurement
By default, measurements are taken from the bottom edge of the device
after it is switched on. The device length is taken into account in the
displayed measurement result.
symbol will appear in the lower-left corner
63