Burg Wächter BURGprotect BASE 2200 Notice D'installation Et D'utilisation page 29

System system and user accounts
System status
Most sensors of the BURGprotect systems are
battery-operated, have a long stand-by time
and notify you automatically when the battery
has to be replaced.
If sensors do not have any connection to the
BASE, e.g. due to environmental influences
and this has not been restored within an hour,
a respective message is generated.
Arm
Disarm
Home scenario
SOS
User accounts
There are three user groups:
ADMINISTRATOR:
An administrator can manage
all system settings.
BASE 2200
BURGprotect_BASE 2200_03-2019_03.indd 29
The system detects jam attempts and reports
these if the connection is impaired.
If the external power supply (power adapter)
should fail, the system will switch to the
internal backup battery.
The following system states are present:
All sensors are active.
An alarm is triggered when the sensor triggers.
All sensors are inactive. No alarm has been triggered. The smoke
detector still remains active.
In this mode, a part of the sensors previously defined by you
remains active. E.g. attics / cellars / garages, etc.
This mode sends an alarm message to the stored persons
and activates the alarm. The mode must only be used in absolute
emergencies.
USER:
Users can change the system
states and, e.g. control the
BURGprotect Plug radio-
controlled socket, etc. Moreover,
you can add users and invite
guests.
GUEST:
Guests can only set and query
the system state.
English | 29
10.04.2019 16:24:3