Güde GF 180 Traduction Du Mode D'emploi D'origine page 7

GB
A.V. 2
Additional copies, even if only extracts, are subject to approval. The right to technical changes reserved.
Marking:
Product safety, prohibitons:
The product is in compliancec
with the relevant EC standards
Prohibitions:
Do not intervene into cutting disk
Prohibitions, Warning:
Warning! Dangerous place!
Orders:
Read the Manual
Environment Protection:
Do not put the waste in the
environment, do dispose it in due
manner
Defective electric or electronic
devices or devices to be disposed
of shall be handed over to the
recycling establishments duly
equipped for this purpose
Packing:
Protect against moisture
Device
GF 180 MACHINE FOR CUTTING THE TILES
Scope of Delivery, (Fig. A)
1. Protection cover
2. Table
3. Scale
4. Parallel rabbet
5. Setting supports
6. On/off switch
7. Tommy screw on parallel rabbet
8. Vessel for water
9. Tommy screw for table adjusting
Please read carefully this manual before putting the advice into operation.
Do not immerse the product.
Keep off the reach of children
Warning against dangerous
electric voltage
Use protection earphones and
eye protectors
Cardboard packing material can
be handed over to the recycling
establishments duly equipped
for this purpose
Orientation of packing. The top
Introduction
This device for tile cutting was designed according to
applicable European regulations and standards. When using
electric devices some safety measures shall be principally
made for prevention of potential injuries and damages.
Therefore read carefully this Manual and keep it so that you
may have any time necessary information available.We do not
bear responsibility for the damage occurred due to breach of
the Manual.
Safety Instructions
Read carefully the whole Manual before the first use of the
device.If there are any doubts about the connection and
attendance of the device, contact the Manufacturer
(Service Department).
BY CAREFUL OBSERVANCE OF FOLLOWING
INSTRUCTION THE HIGH GRADE SAFETY MAY BE
GUARANTEED.
Caution: The device shall be operated only if
furnished with protection switch protecting the device
against insufficient current (maximum insufficient
current 30 mA according to the VCE regulation, part
02). Please contact your electrician-specialist.

Keep order in your working area.
A mess on the workplace may cause injury.

Consider the environment aspects.
Do not expose electric devices to rain. Care for good
lighting. Do not use electric devices close to
inflammable liquids or gases.

Protect yourself against electrical accidents.
Prevent contact of your body with the earthened
parts, e.g. pipes, heating elements, stoves,
refrigerators. Use the device furnished with protection
switch against insufficient current.
* Keep off the reach of children
Do not permit other persons to handle or contact the
device or the cable, keep these persons off your
working area.

Retain your devices safely stored.
When not used, tha devices should be retained in a
dry, closed room, out of the reach of children.

Do not overload the devices.
The devices will work better and more safely in the
specified scope of output.

Use the correct device
Do not use too weak devices for difficult works. Do
not use the devices for the purposes and works thay
are not designated for.

Use suitable working clothes
Do not wear loose clothe or jewelry. They may be
caught by moving parts of the device and cause the
accident to you. When working outside, wear rubber
gloves and slip-resistant shoes. Use hairnet if you
have long hair.