Installation And Preliminary Operations; Installation; Activation Of The Self-Diagnosis Software - Corghi Cal One-Touch Manuel D'utilisation

Indicator lights on the self-diagnosis
module (fig.4)
The self-diagnosis module has two indicator
lights on the sides of the "diagnosis" connector,
and these are highly useful for understanding
the working status of the module.
Green LED indicating activity (1).
This LED indicates that the working status of the
self-diagnosis module:
• Flashing LED: the self-diagnosis module is
powered and is working correctly.
• Fixed LED light: the self-diagnosis module is
powered, but is not working correctly.
In the latter case, you are advised to switch off the
power supply to the module, wait a few seconds
and then repower the module.
Three-colour LED indicating communication
with the vehicle electronics (2).
The colour of this LED indicates the status of
communication between the car system and the
self-diagnosis module:
• orange LED: the self-diagnosis module is trying
to establish a communication with the vehicle
electronics; this condition normally arises when
the communication with the vehicle electronics
is started up.
• green LED: the self-diagnosis module is
communicating with the vehicle electronics and
is updating the parameters requested by the
software.
• red LED: the LED is red when the self-diagnosis
module is waiting for commands from the PC,
or when the communication between the self-
diagnosis module and the vehicle electronics is
in a condition of time-out.
Hardware protocols supported:
ISO9141 – ISO14230 – J1850 PWM – J1850 VPW
– RS485 – ISO15765 – CAN C – J2411.
2
Operator's manual Cal One-Touch
1
4

iNSTallaTiON

aND PrElimiNary
OPEraTiONS
Installation
To install the device, access the Infoauto site,
from where, after registration, you can download
the software for the device and the relative
activation password.
1) Access the Infoauto website.
2) Register (or log-in if you have already
registered).
3) Go to the Downloads section and download
the setup for the Cal One-Touch device. Save
the setup on a USB key.
4) Register the Cal One-Touch device in the section
Devices � Cal One-Touch � INSTALLATION
entering the device's serial number.
5) After registration you will receive the
ACTIVATION PASSWORD for the equipment,
which will also be sent via email.
6) Install the setup on the wheel aligner PC and
follow the instructions on the screen. Enter
the ACTIVATION PASSWORD received from
the website.
At the end of the installation procedure, to use
the Cal One-Touch it is necessary to configure
the aligner. The steps to follow are:
• Insert the USB cable (or the Bluetooth mod-
ule if supplied) in a USB gate of the PC. The
drivers of the device must be sought in the
folder C:\ProgramFiles\Alignment\Esp\Driv-
ers_usb-ad
• Check which COM gate has been associated
with the USB cable or the USB-Bluetooth
device (�My Computer�Properties�Hard
ware�Device Manager�COM Ports)
• Set the COM Port used by the Cal One-Touch
device in the set-up of the aligner, in the Con-
nection Port section.
• Set the type of connection used in the set-
up of the aligner, in the Type of connection
section (USB wireless / Via cable).
• Activate the Cal One-Touch function in the
set-up of the aligner.
Activation of the self-diagnosis
software
At the first use, a message will appear on the
screen, asking you to insert your password. You
must insert the password downloaded from the
EN
17