Vibration Reduction - Nikon AF‑S NIKKOR 70‑200mm f/4G ED VR Manuel D'utilisation

Built-in Flash Units
■
When using the built‑in flash on cameras equipped with a built‑in flash
unit, remove the lens hood to prevent vignetting (shadows created
En
where the end of the lens obscures the built‑in flash).

Vibration Reduction

■
Vibration reduction reduces blur caused by camera shake, allowing
shutter speeds up to five stops slower than would otherwise be the case
(Nikon measurements; effects vary with the photographer and shooting
conditions). This increases the range of shutter speeds available and
permits hand‑held, tripod‑free photography in a wide range of situations.
Using the Vibration Reduction ON/OFF Switch
Using the Vibration Reduction Mode Switch
The vibration reduction mode switch is used to select the vibration
reduction mode when vibration reduction is on.
1
Select ON to enable vibration reduction. Vibration reduction is
activated when the shutter‑release button is pressed
halfway, reducing the effects of camera shake for
improved framing and focus.
Select OFF to turn vibration reduction off.
Select NORMAL to reduce the effects of vibration when
photographing from a fixed position and in other
situations with comparatively little camera motion.
Select ACTIVE to reduce the effects of vibration when
shooting from a moving vehicle, while walking, and in
other situations with active camera motion.