Güde GRK 250/300 Mode D'emploi page 15

Handling Motor
Caution: To avoid any damage of the motor, clean it
(cooling) of the sawdust and dust regularly.
1. Connect the saw to the mains of 230V secured with a 16
A fuse and a protective undercurrent switch. Poor
protection may cause a damage to the motor.
2. If the motor does not start immediately, let the switch go.
UNPLUG .
Check the saw disc for easy run. If it is does run easily,
try restarting again.
3. When the motor stops sudden while cutting is in
progress, push the switch off and unplug the machine.
Release the saw disc from the material cut. Afterwards,
you may finish the job. .
4. Fuses or protection switches may respond to conditions
as follows:
a. THE MOTOR IS OVERLOADED. If the saw
disc is immersed in the material too fast or if the
saw is switched on and off too often, it may
result in the motor overloading or a fault on the
gear.
b. Fluctuations of the mains voltage within a range
of ± 10% will not pose any risk to normal
operation of the saw. However, if the load is too
high, the voltage on the motor connection
terminals should correspond to the plate data.
5. Many problems of the motor may be caused by loosen
or defective connectors, overloading, undervoltage (the
latter may result from too small cross-section of supply
cables). Always check all the connections, voltage value
and the current consumed.
EU Declaration of Conformity
We,
Güde GmbH & Co. KG
Birkichstraße 6
74549 Wolpertshausen
Germany,
hereby declare the conception and construction of the below-
mentioned appliances correspond - at the type of construction
being launched - to appropriate basic safety and hygienic
requirements of EC Directives. In case of any change to the
appliance not discussed with us the Declaration expires.
Marking of appliances:
MITRE-BOX SAW GRK 250/300 #55003
MITRE-BOX SAW GRK 250/500 #55004
MITRE-BOX SAW GRK 210/300 #55006
Order No.:
#55003
#55004
#55006
Appropriate EU Directives:
2006/42 EG
2004/108 EG
Harmonised standards used:
EN 61029-1:2009
EN 61029-2-9:2002
EN 55014-2/A1:2001
EN 61000-3-11:2000*
EN 61000-3-2/A2:2005 (#55003)
EN 55014-1/A2:2002 (#55003)
EN 55014-1:2006 (#55004, #55006)
EN 61000-3-2:2006 (#55004, #55006)
Date/producer signature:
Signed by:
Technical Documentation: J. Bürkle; FBL, QS
29.04.2011
Mr. Arnold, Managing Director