Reely Hydro Force Notice D'emploi page 45

Driving time is approx. 5 to 8 minutes, depending on driving style and battery used. Terminate the trip in time and
return to the shore. Open the hull deck, unplug the drive battery, switch off the transmitter and check if any water has
entered the model. Ingressing water must be removed at once. Observe that the water does not enter the remote
control or drive parts during emptying.
Low water volumes entering (max. approx. 30 - 50 ml per trip) is normal; it must be emptied after every
operation. After a trip, the motor and speed control must cool off to ambience temperature. Therefore, make
a break of approx. 5 to 10 minutes before the next trip. The hull deck should remain disassembled for better
cooling.
Practical advice:
If water ingression increases continually, the grease has usually been flushed from the drive shaft. In this
case, the shaft must be removed and re-lubricated. Observe the notes in chapter „Maintenance and Care"
for this.
45